8-26 ELECTRICAL SYSTEM
• Repeat the above procedure a few times and measure the
highest ignition coil primary peak voltage.
' Tester knob indication: Voltage (&)
$ Ignition coil primary peak voltage: 150 V and more
0
• If the peak voltage is lower than the specified values, inspect
the ignition coil. (!8-26)
IGNITION COIL RESISTANCE
• Lift and support the fuel tank. (!5-7)
• Disconnect the spark plug caps and ignition coil lead wires.
Measure the ignition coil resistance in both the primary and sec-
ondary windings. If the resistance is not within the standard
range, replace the ignition coil with a new one.
# 09900-25008: Multi circuit tester set
( Tester knob indication: Resistance (Ω)
$ Ignition coil resistance
Primary : 2 – 5 Ω (
+ terminal –
- terminal)
Secondary : 24 – 37 kΩ (Plug cap –
+ terminal)
While testing, do not touch the tester probes and
spark plugs to prevent receiving an electric shock.
kΩ
Ω
PartShark.com
877-999-5686
To Next Page
Loading...
