TP SENSOR ADJUSTMENT
After all adjustments are completed, check or adjust the TPS
setting condition.
1. Warm up the engine and check the engine idle r/min.
2. Remove the seat. (!DL650K4 7-4)
3. Connect the special tool (Mode select switch) to the dealer
mode coupler at the wiring harness. (!Page 64)
4. Lift and support the fuel tank. (!DL650K4 5-7)
5. If the throttle position sensor adjustment is necessary, loosen
the screw and turn the throttle position sensor and bring the
line to the middle.
6. Then, tighten the screw to fix the throttle position sensor.
# 09930-11950: Torx wrench
09930-82720: Mode select switch
The LCD displays the line for 0.4 sec. at a time, and when such
a display repeats two times, it indicates the current position
where the sensor is fixed.
A Incorrect
B Correct position
13-60 DL650K7/AK7 (’07-MODEL)
PartShark.com
877-999-5686
To Next Page
Loading...
