9F-3 Security and Locks:
Keyless Entry System Symptom Diagnosis (If Equipped)
S5JB0A9604004
NOTE
• Confirm that power door lock system is in good condition before referring to the following possible
causes.
• Check each part in the order from the top of the following list.
Condition Possible cause Correction / Reference Item
All door can not be locked
/ unlocked by only
keyless entry transmitter
Transmitter battery dead Replace battery referring to “Replacement of
Transmitter Battery: ”.
Door switch faulty Check door switch referring to “Door Switch
(Front / Rear / Rear End Door) Inspection: in
Section 9C”.
Transmitter faulty Replace transmitter.
Key remainder switch in ignition switch
faulty
Check ignition switch referring to “Ignition
Switch Inspection: in Section 9C”.
Wiring or grounding faulty Repair circuit.
Keyless entry receiver faulty Check keyless entry receiver referring to
“Keyless Entry Receiver and Its Circuit
Inspection: ”.
BCM faulty Replace after making sure that none of above
parts is faulty.
Turn signal lights can not
be flashed when doors
are locked / unlocked by
keyless entry transmitter
Turn signal and hazard warning relay
faulty
Check turn signal and hazard warning relay
referring to “Turn Signal and Hazard Warning
Relay Inspection: in Section 9B”.
Wiring or grounding faulty Repair circuit.
BCM faulty Replace after making sure that none of above
parts is faulty.
Interior light does not
light when doors are
unlocked by keyless entry
transmitter
Wiring or grounding faulty Repair circuit.
BCM faulty Replace after making sure that none of above
parts is faulty.
Hazard warning lights do
not light when doors are
locked/unlocked by
keyless entry transmitter
Turn signal and hazard warning relay
faulty
Check turn signal and hazard warning relay
referring to “Turn Signal and Hazard Warning
Relay Inspection: in Section 9B”.
Wiring or grounding faulty Repair circuit.
BCM faulty Replace after making sure that none of above
parts is faulty.
Transmitter code can not
be programmed to BCM
Door switch faulty Check door switch referring to “Door Switch
(Front / Rear / Rear End Door) Inspection: in
Section 9C”.
Keyless entry receiver faulty Check keyless entry receiver referring to
“Keyless Entry Receiver and Its Circuit
Inspection: ”.
Key reminder switch in ignition switch
faulty
Check ignition switch referring to “Ignition
Switch Inspection: in Section 9C”.
Wiring or grounding faulty Repair circuit.
BCM faulty Replace after making sure that none of above
parts is faulty.