Maintenance and Lubrication: 0B-7
Exhaust system Inspection
S5JB0A0206006
WARNING
!
To avoid danger of being burned, do not
touch exhaust system when it is still hot. Any
service on exhaust system should be
performed when it is cool.
When carrying out periodic maintenance, or the vehicle
is raised for other service, check exhaust system as
follows:
• Check rubber mountings for damage, deterioration,
and out of position.
• Check exhaust system for leakage, loose
connections, dents and damages.
If bolts or nuts are loose, tighten them to specification.
• Check nearby body areas for damaged, missing, or
mispositioned parts, open seams, holes, loose
connections or other defects which could permit
exhaust fumes to seep into the vehicle.
• Make sure that exhaust system components have
enough clearance from the underbody to avoid
overheating and possible damage to the floor carpet.
• Any defects should be fixed at once.
Spark Plugs Replacement
S5JB0A0206010
Replace spark plugs with new ones referring to “Spark
Plug Removal and Installation: in Section 1H”.
Air Cleaner Filter Inspection
S5JB0A0206014
Check that filter is not excessively dirty, damaged or oily
and clean filter with compressed air from air outlet side
of filter.
Refer to “Air Cleaner Filter Inspection and Cleaning: For
M16A Engine with VVT in Section 1D” or “Air Cleaner
Filter Inspection and Cleaning: For J20 Engine in
Section 1D”.
Air Cleaner Filter Replacement
S5JB0A0206013
Replace air cleaner filter with new one referring to “Air
Cleaner Filter Removal and Installation: For M16A
Engine with VVT in Section 1D” or “Air Cleaner Filter
Removal and Installation: For J20 Engine in Section 1D”.
Fuel Lines and Connections Inspection
S5JB0A0206016
Visually inspect fuel lines and connections for evidence
of fuel leakage, hose cracking and damage. Make sure
all clamps are secure.
Repair leaky joints, if any.
Replace hoses that are suspected of being cracked.
Fuel Filter Replacement
S5JB0A0206015
WARNING
!
This work must be performed in a well
ventilated area and away from any open
flames (such as gas hot water heaters).
Fuel filter is installed in fuel pump assembly in fuel tank.
Replace fuel filter or fuel pump assembly with new one,
referring to “Fuel Pump Assembly Removal and
Installation: in Section 1G”.
Fuel Tank Inspection
S5JB0A0206044
Check fuel tank for damage, cracks, fuel leakage,
corrosion and tank bolts looseness.
If a problem is found, repair or replace.
Crankcase Ventilation Hoses and Connections
Inspection (Vehicle without A/F Sensor)
S5JB0A0206045
Check crankcase ventilation hose and connections for
leaks, cracks or clog. Repair or replace if necessary.
PCV Valve Inspection
S5JB0A0206046
Check crankcase ventilation hose and PCV hose for
leaks, cracks or clog, and PCV valve for stick or clog.
Refer to “PCV Valve Inspection: in Section 1B” for PCV
valve checking procedure.
I5JB0A020022-01
To Next Page
Loading...
Need help?
General
