5-30 CHASSIS
Rear brake cam Indicator plate
• Install the rear brake indicator plate 1, spring 2, and rear brake
cam lever 3.
• When installing the brake cam lever on the camshaft, align the
punch mark 4 of the cam lever with the slit 5 of the camshaft.
NOTE:
A line the groove
A
on the cam shaft with the tongue
B
of the
indicator plate.
• Tighten the rear brake cam lever nut to the specified torque.
! Rear brake cam lever nut: 7.5 N
.
m (0.75 kgf
.
m, 5.5 lb-ft)
• Install the rear brake panele.
• Tighten the rear brake panel nut to the specified torque.
!!
!!
! Rear brake panel nut: 28 N
.
m (2.8 kgf
.
m, 20.5 lb-ft)
• Apply SUZUKI SUPER GREASE “A” to the brake cam and pin.
• Install the brake shoes.
For USA
& 99000-25030: SUZUKI SUPER GREASE “A”
For the others
& 99000-25010: SUZUKI SUPER GREASE “A”
'
Be careful not to apply too much grease to the cam and
pin. If grease gets on the lining, brake slippage will re-
sult.
To Next Page
Loading...
