3B-28 Differential:
• Install the final drive gear bearing (1) to the final gear
case with the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
• Install the final drive bearing (2) with the special tool.
Special tool
(C): 09913–84510 (Bearing installer)
• Install the washer (3) and lock-nut (4) to the final drive
gear.
CAUTION
!
The removed lock-nut (4) must be replaced
with a new one.
• Tighten the lock-nut (4) to the specified torque with
the special tool.
Tightening torque
Final drive lock-nut (a): 100 N·m (10.0 kgf-m, 72.5
lb-ft)
Special tool
(D): 09924–52470 (Fixed final drive gear
holder)
(E): 09940–92430 (Rear axel wrench A)
• Lock the nut with a center punch.
• Install the shim(s) (5) and final drive gear (6) to the
final gear case.
1
(A)
I831G1320113-01
(C)
2
I831G1320114-03
3
4
I831G1320115-01
(a)
4
(D)
(E)
I831G1320116-02
I831G1320117-01
5
6
I831G1320118-02
To Next Page
Loading...
