4-4 SHAFT DRIVE
REMOVAL
SECONDARY DRIVE BEVEL GEAR
The crankcase must be separated to service the secondary drive
bevel gear. The secondary drive bevel gear service requires en-
gine removal and disassembly. Refer to the engine removal and
the engine disassembly sections for secondary drive bevel gear
assembly removal.
Engine removal "3-3
Engine disassembly "3-11
SECONDARY DRIVEN BEVEL GEAR
The following components must be removed in the described or-
der before removing the secondary driven bevel gear.
NOTE:
Refer to the following pages for the details of each step.
• Remove the rear wheel. ("7-38)
• Remove the swingarm. ("7-48)
• Remove the universal joint.
• Remove the secondary driven bevel gear.
DISASSEMBLY
SECONDARY DRIVE BEVEL GEAR
• Compress the damper spring with a vice, and remove the circlip
with the special tool.
# 09900-06107: Snap ring pliers
• Remove the cam dog 1 and damper spring 2.
$
Do not attempt to remove the secondary drive bevel gear
bearing. The secondary drive bevel gear and its bearing
are available only as an assembly.
To Next Page
Loading...
