4-14 SHAFT DRIVE
• Remove the bearing from the final drive bevel gear with the
bearing puller.
$
The removed bearing must be replaced with a new one.
NOTE:
If no abnormal noise, the bearing removal is not necessary.
• Remove the final gear bearing case bolts.
• Remove the final gear bearing case from the final gear case,
by using two 5 mm screws.
• Remove the final driven bevel gear and shims.
• Remove the oil seal with the special tool.
# 09913-50121: Oil seal remover
NOTE:
If no oil leakage, the oil seal removal is not necessary.
To Next Page
Loading...
