SHAFT DRIVE 4-15
• Remove the bearing retainer screws, using an impact driver
set.
# 09900-09004: Impact driver set
• Remove the final driven gear bearing and oil seal with the spe-
cial tools.
# 09941-64511: Bearing remover
09930-30102: Sliding shaft
$
The removed bearing and oil seal must be replaced with
new ones.
NOTE:
If no abnormal noise, the bearing removal is not necessary.
• Remove the final drive gear bearing with the special tools
# 09923-73210: Bearing remover
09930-30102: Sliding shaft
$
The removed bearing must be replaced with a new one.
NOTE:
If no abnormal noise, the bearing emoval is not necessary.
• Remove the oil seal 1 and O-ring 2 from the bearing stopper.
$
The removed oil seal and O-ring must be replaced with
new ones.
NOTE:
If no oil leakage, the oil seal removal is not necessary.
INSPECTION
Inspect the removed parts for the following abnormalities.
* Drive and driven bevel gear damage or wear
* Improper tooth contact
* Abnormal noise of bearings
* Bearing damage or wear
* Oil seal damage or wear
* Propeller shaft spline damage or wear
To Next Page
Loading...
