SHAFT DRIVE 4-19
FINAL GEAR CASE REASSEMBLY
Reassemble the final gear case in the reverse order of disassem-
bly. Pay attention to the following points.
• Install a new oil seal 1 and O-ring 2 to the bearing stopper.
$
Use new O-ring and oil seat to prevent oil leakage.
• Install the bearing to the final drive bevel gear with the special
tool.
# 09913-84510: Bearing installer
$
When replacing the drive bevel gear replace the driven
bevel gear also, as they must be replaced together.
• Install the needle roller bearing or the final drive bevel gear
into the final gear case with the special tool.
# 09913-75821 : Bearing installer
• Install the oil seal into the final gear case.
$
* Use a new oil seal to prevent oil leakage.
* The lip and spring of the oil seal should face to the
driven bevel gear side.
To Next Page
Loading...
