4-20 SHAFT DRIVE
• Install the needle roller bearing for the final driven bevel gear
into the final gear case with the special tool.
# 09913-76010: Bearing installer
NOTE:
The stamped ward on the bearing end should face to the driven
bevel gear side.
• Install the bearing retainer. Apply a small quantity of the
THREAD LOCK “1342” on the screws, and tighten them to the
specified torque.
'99000-32050: THREAD LOCK ‘‘1342’’
! Bearing retainer screw: 9 N
.
m (0.9 kgf
.
m, 6.5 lb-ft)
• Install a new oil seal to the final gear bearing case.
• Apply final gear oil to the lip of the oil seal.
To Next Page
Loading...
