Suzuki VL800 - Page 132

SHAFT DRIVE 4-21
• Apply SUZUKI BOND “1207B” to the mating surface of the final
gear case and final gear bearing case.
$
Do not block the breather passage when applying
SUZUKI BOND “1207B”.
( 99000-31140: SUZUKI BOND “1207B”
• Apply THREAD LOCK “1342” to the final gear case bolts and
tighten them to the specified torque.
! Final gear case bolt: 23 N
.
m (2.3 kgf
.
m, 16.5 lb-ft)
'99000-32050: THREAD LOCK ‘‘1342’’
• Install the correct shims to the final drive bevel gear and install
the bevel gear to the final gear case.
Shim adjustment ("4-16)
• Apply oil to the O-ring and the oi seal.
• Install the bearing stopper.
• Tighten the bearing stopper to the specified torque with the
special tool.
# 09924-62410: Final drive gear bearing holder wrench
! Final drive bevel gear bearing stopper: 110 N
.
m
(11.0 kgf
.
m, 79.5 lb-ft)