Suzuki VL800 - Page 133

4-22 SHAFT DRIVE
• Apply a small quantity of the THREAD LOCK “1303” to the
final drive bevel gear coupling nut.
'99000-32030: THREAD LOCK ‘‘1303’’
• Tighten the nut to the specified torque with the special tool.
! Final drive bevel gear coupling nut: 100 N
.
m
(10.0 kgf
.
m, 72.5 lb-ft)
# 09924-62430: 22 mm Long socket
09924-64510: Final drive gear coupling holder
• Lock the final drive bevel gear coupling nut with a center punch.
• Apply Lithium Base Molybdenum grease (NLGI #2) to the pro-
peller shaft splines and final drive bevel gear coupling.
• Install the spring 1 and propeller shaft 2.
• Install the circlip.
• After installing the propeller shaft with a new circlip, make sure
that the propeller shaft turns smoothly without any hitch or bear-
ing noise.
# 09900-06108: Snap ring pliers
• Apply grease to the lip of the oil seal and install it to the final
drive bevel gear coupling.
$
Use a new oil seal to prevent oil leakage.
& 99000-25030: SUZUKI SUPER GREASE ‘‘A’’ (For USA)
99000-25010: SUZUKI SUPER GREASE ‘‘A’’
(For the others)