7-54 CHASSIS
NOTE:
After tightening the swingarm pivot lock nut, be sure to check the
swingarm operation.
SHOCK ABSORBER AND CUSHION LEVER MOUNTING
NUT
• Tighten the shock absorber upper mounting nut 1 to the speci-
fied torque.
$ Shock absorber mounting nut: 50 N
.
m
(5.0 kgf
.
m, 36.0 lb-ft)
• Tighten the cushion lever mounting nut 2 to the specified torque.
$ Cushion lever mounting nut: 78 N
.
m (7.8 kgf
.
m, 56.5 lb-ft)
• Apply Lithium Base Molybdenum grease (NLGI #2) to the pro-
peller shaft spline.
FINAL GEAR CASE
• Install the plate to the final gear case 1. Apply SUZUKI BOND
“1207B” to the mating surface of swingarm and final gear case
For USA
* 99104-31140: SUZUKI BOND ‘‘1207B”
For the other countries
* 99000-31140: SUZUKI BOND ‘‘1207B”
!
When installing the plate 1, align the lug A of the plate
1 to the bearing retainer groove.
To Next Page
Loading...
