8-24 ELECTRICAL SYSTEM
To oil pressure
switch
INSPECTION
ENGINE COOLANT TEMPERATURE INDICATOR LIGHT
Engine coolant temperature sensor inspection: &6-8
• Remove the fuel tank. (&5-3)
• Disconnect the engine coolant temperature sensor coupler.
• Connect the jumper wire to the wire harness coupler.
Check that the LED light immediately after turning the ignition
switch on. If the LED fail in operation, replace the speedometer
unit with a new one.
Main wiring
harness
To engine coolant
temp. sensor
OIL PRESSURE INDICATOR LIGHT
NOTE:
Before inspecting the oil pressure switch, check if the engine oil
level is enough. (
&
2-8)
• Disconnect the oil pressure switch lead wire from the oil pres-
sure switch.
• Turn the ignition switch “ON” position.
Check if the oil pressure indicator will light, when grounding the
lead wire.
To Next Page
Loading...
