ELECTRICAL SYSTEM 8-25
Main wiring
harness
To fuel level
gauge
Resistor
FUEL LEVEL METER
• Remove the fuel tank. (&5-3)
• Connect the speedometer.
• Connect each resistor between the Yellow/Black and Black/
White lead wire at the wire harness.
• Turn the ignition switch “ON” position and wait for approx, 13
seconds.
Check the display of fuel meter as shown below. If any abnormal-
ity is found, replace the speedometer with a new one.
Resistance
Less than
22 – 28 Ω 33 49 Ω 54 – 69 Ω 74 – 83 Ω
More than
17 Ω 94 Ω
Fuel level
meter
Flicker
To Next Page
Loading...
