VL800K5 (’05-MODEL) 14-77
Is the voltage OK?
6) After repairing the trouble, clear the DTC using SDS tool.
($14-39)
YES
• Y/W, R or B/Br wire open or shorted to ground,
or poor
4,
6 or
D connection.
• If wire and connection are OK, intermittent trou-
ble or faulty ECM.
• Recheck each terminal and wire harness for
open circuit and poor connection.
• Replace the ECM with a known good one, and
inspect it again.
NO
If check result is not satisfactory, replace STP
sensor with a new one.
Wire harness side
To Next Page
Loading...
