VL800K5 (’05-MODEL) 14-81
Step 2
1) Turn the ignition switch ON.
2) Measure the injector voltage between Y/R wire and ground.
! Injector voltage: Battery voltage
(
+ Y/R –
- Ground)
NOTE:
Injector voltage can be detected only for 3 seconds after ignition
switch is turned ON.
" 09900-25008: Multi-circuit tester set
& Tester knob indication: Voltage (')
Is the voltage OK?
3) After repairing the trouble, clear the DTC using SDS tool.
($14-39)
YES
• Gr/B or Gr/W wire open or shorted to ground, or
poor
^ or
a connection.
• If wire and connection are OK, intermittent trou-
ble or faulty ECM.
• Recheck each terminal and wire harness for
open circuit and poor connection.
• Replace the ECM with a known good one, and
inspect it again.
NO Open circuit in the Y/R wire.
2
V
Wire harness side
To Next Page
Loading...
