VL800K5 (’05-MODEL) 14-109
• Install the O-ring and dust seal to each fuel injector.
• Apply thin coat of the engine oil to the new O-ring and cushion
seal.
#
• Install the fuel injectors
3 by pushing them straight to each
throttle body.
#
• Install the fuel delivery pipes
4 to the throttle body assembly.
#
• Tighten the fuel delivery pipe mounting screws to the speci-
fied torque.
* Fuel delivery pipe mounting screw:
3.5 N·m (0.35 kgf-m, 2.45 lb-ft)
• Apply thin coat of the engine oil to the new O-rings.
#
Replace the O-ring and cushion seal with the new
ones.
Never turn the injector while pushing it.
Never turn the fuel injectors while installing them.
Replace the O-rings wi h the new ones.
To Next Page
Loading...
