Suzuki VL800 - Page 587

VL800/C/TK9 (’09-MODEL) 18-47
• With the STV fully opened, install the STP sensor 2 and
tighten the STP sensor mounting screw to the specified
torque.

STP sensor 2: Green color coupler
NOTE:
* Apply thin coat of engine oil to the new O-ring.
* Align the secondary throttle shaft end A with the groove B of
STP sensor.
* Apply engine oil to the secondary throttle shaft end A if neces
sary.
 09930-11950: Torx wrench

STP sensor mounting screw: 3.5 N·m (0.35 kgf-m, 2.5 lbf-ft)
NOTE:
* Make sure the STP valve open or close smoothly.
* If the STP sensor adjustment is necessary, refer to page 51 for
STP sensor setting procedure.
• With the throttle valve fully closed, install the TP sensor 3
and tighten the TP sensor mounting screw to the specified
torque.
NOTE:
* Apply thin coat of engine oil to the new O-ring.
* Align the throttle shaft end C with the groove D of TP sensor.
* Apply engine oil to the throttle shaft end C if necessary.
 09930-11950: Torx wrench

TP sensor mounting screw: 3.5 N·m (0.35 kgf-m, 2.5 lbf-ft)
NOTE:
* Make sure throttle valve open or close smoothly.
* TP sensor setting procedure. (Page 18-52)
TPS and STPS resemble each other very closely in
external appearance.
Make sure to check the color of coupler before install-
ing.