Table 11-4
Steps for replacing an appliance with recoverable operating system
drives and attached disk storage (continued)
DescriptionActionSteps
Symantec Technical Support
dispatches service personnel
to you who then help you get
your new appliance installed
and configured.
Remove the damaged
appliance and replace with a
new appliance.
Step 2
Symantec Technical Support
dispatches service personnel
to you who install the drives
into the new appliance.
Install the operating system
and storage disks into the
new appliance.
Step 3
Turn on the components in
the following order:
■ Turn on the storage shelf
that is the furthest away
from the appliance and
wait until the initialization
completes.
■ Turn on the storage shelf
that is nearest to the
appliance and wait until
the initialization
completes.
■ Turn on the main
appliance.
Note: If your environment
contains multiple appliances,
recover the master server
appliance first, then the media
server second.
Turn on the components.Step 4
Once you have verified that
the status of the appliance
hardware is healthy, check to
make sure that all NetBackup
services have resumed. All
backup jobs resume once the
appliance is turned on.
Verify that all NetBackup
services have started.
Step 5
123Disaster Recovery
Disaster recovery scenarios
To Next Page
Loading...
