- [Info] Rebooting appliance to complete the reset.
Please reconnect to the Appliance shell menu to continue using this appliance
5
You must use the remote management remote management port to reconfigure
the network settings and reconnect to the NetBackup Appliance Web Console.
Perform the following steps:
■ When the appliance restarts and you see the keyboard prompts at the top
of the screen, Hit the F2 function key on the keyboard.
■ Use the left arrow and the right arrow on your keyboard to navigate to the
Server Management menu.
■ Use the up and down arrows on your keyboard to navigate to the Baseboard
LAN configuration section.
■ Select the RMM4 LAN Configuration section.
■ Enter the network configuration information, such as the IP source [Static],
IP, Subnet mask, and Gateway IP addresses.
■ You can now connect to the appliance NetBackup Appliance Web Console.
NetBackup appliance operating system corruption
Operating system corruption may have occurred if you are not able to log in or you
are not able to perform any of the NetBackup or NetBackup appliance operations.
Use the following steps as a guide to recover a corrupt operating system on the
appliance.
164Disaster Recovery
Disaster recovery scenarios
To Next Page
Loading...
