NetBackup status codes applicable for NetBackup
Appliance
This section lists the NetBackup error that can occur while, working with a NetBackup
Appliance. It helps you to resolve the issues based on the corresponding error
messages:
Table 12-22
NetBackup status codes
ExplanationMessageNetBackup
status code
A read of a file or socket failed.file read failed13
The system function gethostbyname() failed to find
the client’s host name.
client host name cannot be found48
The tape manager (bptm) or disk manager (bpdm) did
not open the device or file that the backup or restore
must use.
media open error83
The system’s device driver returned an I/O error while
NetBackup wrote to removable media or a disk file.
media write error84
The NetBackup processes use shared memory for
some operations. This status is returned when an error
is encountered in the initialization of the shared memory
by the operating system’s APIs.
problems encountered during setup of
shared memory
89
The NetBackup resource broker (nbrb) did not find any
storage units available for use. Either all storage units
are unavailable or all storage units are configured for
On demand only. In addition, the policy and schedule
does not require a specific storage unit.
no storage units available for use213
If the request is processed, it causes a duplicate entry
(for example, in the catalog or the configuration
database). A duplicate catalog entry is usually due to
a mistake in the specification of media IDs for
NetBackup catalog backups.
operation would cause an illegal duplication242
The storage unit or storage unit group specified for one
or more destinations in storage lifecycle policy is not
valid.
Invalid storage unit1500
For more information on NetBackup status codes, refer to Symantec NetBackup™
Status Codes Reference Guide.
196NetBackup Appliance error messages
NetBackup status codes applicable for NetBackup Appliance
To Next Page
Loading...
