Table 12-21
Main_Menu > Network view (continued)
Recommended actionExplanationError message
To create a bond, provide interface
details for more than one interface.
This error is displayed if you provide
a information for a single interface for
creating a bond.
Cannot enable bonding for a single
interface. To enable bonding, provide
details for more than one interface.
Ensure that the interface that are
selected for creating a bond have
same port speed.
This error occurs when you try to
create a bond with interfaces that have
different port speeds.
Interfaces <interface(s)> are not of
same type and speed.
Ensure that the interfaces that is
selected for the operation is not
already a part of a bond.
This error occurs when you provide
details of an interface that is already
a part of another bond.
Interface <interface> is part of a bond.
Do not enter duplicate interfaces
names while creating a bond.
This error is displayed if you enter
duplicate interface names while
creating a bond. For example, <eth3>,
<eth4>, <eth4>
Cannot enable bonding for duplicate
interface(s), <eth4> To enable
bonding, provide details for different
interface(s)
Ensure that the interfaces that is
selected for creating a bond is not a
part of an existing bond.
This error is displayed if you try to
create a bond over using an interface
that is already a part of another bond.
Interface <bond0> is a bonded
interface. Cannot use bonded
interfaces in bond.
Enter details for an interface that does
not have any VLAN(s) tagged over it.
This error occurs when you try to
create a bond using an interface over
which a VLAN is tagged.
Cannot use interface <eth4> in a bond.
Interface is in use by VLAN <vlan12>.
To create a bond between interfaces,
IP address should not be configured
for more than one interface.
This error occurs when you try to
create a bond with interfaces for which
have IP addresses are configured.
More than one interfaces
(eth4:10.10.10.10 eth5:10.10.10.11 )
are configured. Use
Main->Network->Unconfigure to
remove one.
See “NetBackup status codes applicable for NetBackup Appliance” on page 196.
See “Error messages displayed on the NetBackup Appliance Shell Menu”
on page 189.
See “Error messages displayed during initial configuration” on page 168.
195NetBackup Appliance error messages
Error messages displayed on the NetBackup Appliance Shell Menu
To Next Page
Loading...
