Table 11-6
Steps for replacing an appliance and attached storage disk units
after they have been rendered non-operational (continued)
DescriptionActionSteps
Power on the components in the following order:
■ Storage systems
■ Master server
■ Media server
Power on the new components.Step 3
Configure the appliance as you would a new
configuration.
See the "Initial Configuration" chapter of the
Symantec NetBackup 52xx Appliance Hardware
Installation and Initial Configuration Guide for
more information on setting up your appliance
and attached storage systems.
Configure the appliance and
storage systems.
Step 4
If you have a secondary backup site, Symantec
Technical Support will help you work through
recovering your data from a secondary backup
site.
Recover the data from a
secondary backup site.
Step 5
NetBackup appliance software corruption
Use the following steps as a guide to determine the type of software corruption you
are experiencing and where you can get more information on your specific scenario
154Disaster Recovery
Disaster recovery scenarios
To Next Page
Loading...
