Table 12-20
Manage > Appliance Restore view (continued)
Recommended actionExplanationError message
Look for additional information listed
above the error message. Try to
correct and retry the operation.
Secured network communication has
issues.
Factory reset validation failed. Unable
to continue. Please fix the errors
above and try again.
Restart the appliance and retry factory
reset.
System resources could be busy.Reset of the appliance to a Factory
State failed. Please proceed with the
suggested system reboot. Some reset
failures can be resolved by rebooting
the appliance(s).
Table 12-21 lists error messages that are specific to Main_Menu > Network
commands.
Table 12-21
Main_Menu > Network view
Recommended actionExplanationError message
Provide a valid numeric identifier for
the <vlan_id>.
This error occurs when you enter an
enter invalid interface.
Failed to create VLAN <vlan_id>.
Ether device {interface} does not exist.
Enter an IP address that is not
configured to another interface.
Alternatively, you may also
unconfigure the existing IP address for
the given interface and then tag VLAN.
This error occurs when you try to tag
a VLAN over an interface that is
configured with an IP address .
Failed to create VLAN <vlan12>.
Interface <eth4> is configured with IP
address 10.10.10.10. Cannot create
a VLAN device over a configured
interface. Unconfigure the IP before
adding a VLAN device.
Ensure that the interface that is
selected for tagging VLAN is plugged.
This error occurs when you try to tag
a VLAN over an unplugged interface.
Failed to create VLAN <vlan12>.
Interface <eth2> is not cabled.
Ensure that the interfaces that is
selected for VLAN tagging is not
already a part of a bond.
This error is displayed if you try to tag
a VLAN over a bonded interface.
Failed to create VLAN <vlan12>.
Interface <eth4> is slave to bond
<bond0> .Cannot create a VLAN over
a bonded interface.
Enter a valid interface name for
creating a bond.
This error occurs if you enter an invalid
interface name for creating bond using
the LinkAggregation command.
Interface {interface} does not exist.
Ensure that at least one of the
interfaces that participates in bond
creation is plugged.
This error is displayed if any of the
interfaces that participate in creating
bond are unplugged.
None of the given interfaces
<interface(s)> are cabled. Make sure
at least one interface is cabled.
194NetBackup Appliance error messages
Error messages displayed on the NetBackup Appliance Shell Menu
To Next Page
Loading...
