To begin a factory reset from the appliance shell menu
1
Log on to the appliance as an administrator an open the appliance shell menu.
2
Enter Main_Menu > Support > FactoryReset. This command shows the
following messages and requires you to answer the following questions before
the factory reset begins.
Appliance factory reset will reset the entire system
to the factory installed image. The appliance will have the following components
reset to the factory restored settings/image:
1) Appliance Operating System
2) Appliance Software
3) NetBackup Software
4) Tape media configuration on the master server
5) Networking configuration (optionally retain)
6) Storage configuration and backup data (optionally retain)
- [Info] Running factory reset validation...please wait (approx 2 mins)
- [Info] Factory reset validation successful.
RESET NETWORK CONFIGURATION [Optional]
-- Resets the IP and routing configuration.
-- Resets the DNS configuration.
>> Do you want to reset the network configuration? [yes/no] (yes) no
RESET STORAGE CONFIGURATION and BACKUP DATA [Optional]
-- Removes all the images on the AdvancedDisk and MSDP storage pools.
-- Resets the storage partitions.
-- Resets storage expansion units, if any.
>> Do you want to delete images and reset backup data? [yes/no] (yes)
>> Resetting the storage configuration will remove all backup
data on the storage partitions and any connected expansion
units. This is not reversible. Are you sure you want to
reset storage configuration? [yes/no] (yes)
>> A reboot of the appliance is required to complete the factory reset.
Reboot automatically after reset? [yes/no] (no) yes
>> Automatically rebooting after the reset will not provide you with an
opportunity to review the progress/final status of the reset. Are you sure
you would like to automatically reboot? [yes/no] (no) yes
161Disaster Recovery
Disaster recovery scenarios
To Next Page
Loading...
