- [Info] Summary of storage configuration.
-> NetBackup Catalog volume size: 250 GB
-> AdvancedDisk storage pool size: 1 TB
-> AdvancedDisk storage diskpool name: dp_adv_nbuappliance
-> AdvancedDisk storage unit name: stu_adv_nbuappliance
-> Dedupe storage configuration: None
The estimated time to configure storage is 3 minutes. The greater total storage size
you specify, the longer it takes to complete the storage configuration.
>> Do you want to edit the storage configuration? [yes,no]: no
- [Info] Removing existing NetBackup configuration on appliance 'nbuappliance'
- [Info] Stopping NetBackup processes.
- [Info] Removing current NetBackup configuration.
- [Info] Performing Deduplication Engine cleanup.
- [Info] Configuring appliance 'nbuappliance' as NetBackup master appliance
- [Info] Creating basic NetBackup configuration on appliance 'nbuappliance'
- [Info] Reconfiguring NetBackup databases
- [Info] Configuring NetBackup logging on appliance 'nbuappliance'
- [Info] Starting NetBackup processes on appliance 'nbuappliance'
- [Info] Waiting for NetBackup processes to start
- [Info] Configuring storage partitions for appliance 'nbuappliance'
- [Error] Failed to save the AdvancedDisk disk pool name in the NetBackup Appliance
Directory. Retry this operation. If the issue persists, see the NetBackup Appliance
Troubleshooting Guide.
- [Error] Could not configure the appliance.
To resolve the issue restart the appliance and try again. If the issue is not resolved,
perform a factory reset and try again. If the issue persists contact Symantec
Technical Support.
Note: Always ensure that the NetBackup processes are up and running before you
perform a Role Configuration.
See “About best practices” on page 17.
See “Troubleshooting the appliance setup and configuration issues” on page 59.
69Troubleshooting the NetBackup Appliance setup and configuration issues
Failure to complete role configuration when NetBackup Appliance Directory is down
To Next Page
Loading...
