Symmetricom TimeProvider 1100 Reference Guide

097-58001-01 Revision E – September 2006 TimeProvider TL1 Reference Guide 165
Appendix C Events
SSMBIT Allows the user to
provision E1 bit position
and generate SSMs on
the specified bit position.
CRC must be enabled to
allow SSM generation.
T1 ALL 4 | 5 | 6 | 7 | 8 | ALL
EIA-422 Output Event Codes
CKTIDCHG A user has modified the
Circuit ID for the output.
T1 GPS The ID can be up to 40 characters
in length.
FRMTYPE Allows the user to
provision the type of input
framing or the input
frequency.
Allows the user to
provision the output
framing type.
T1 OUTPUT =
1.544M
1.544M – 1.544 MHz
2M – 2.048 MHz
FREEFLT Defines if the output fault
is set or not set when the
LO enters Free-run mode
of operation. The output
groups are provisioned
for fault strategies.
T1 SQUELCH
 ON – In fault mode generate
outputs based upon system
SSM
 AIS – In fault mode generate
AIS outputs
 SQUELCH – In fault mode
outputs are turned off
HOLDFLT Defines if the output fault
are set or not set when
the LO enters Holdover
mode of operation. The
output groups are
provisioned for fault
strategies.
T1 ON
 ON – In fault mode generate
outputs based upon system
SSM
 AIS – In fault mode generate
AIS outputs
 SQUELCH – In fault mode
outputs are turned off
OUTSTATE The specified output
state has changed
T1 DISABLE
 ENABLE – Enable the output
to generate the defined signal
type
 DISABLE – Disable the output
NTP Event Codes
AUTHEN Allows the user to enable
or disable NTP
Authentication. This
parameter applies to both
Server and Peer.
EQPT DISABLE
 ENABLE – NTP
Authentication is enabled
 DISABLE – NTP
Authentication is disabled
Table C-1. Event Identifiers (Continued)
Event ID
or
CONDTYPE
Event Description
AID
TYPE
Default Value Value Description

Symmetricom TimeProvider 1100 Specifications

General

Brand	Symmetricom
Model	TimeProvider 1100
Category	Clock
Language	English