Issue 2: Sep 99 TMSL 097-44018-26
Page 11
3. SECURITY
3.01
The access level of each command is listed in
Table B. The access levels are from 1 (lowest) to 5
(highest). Each user is assigned an access level allow-
ing access to all commands at that level and below. A
user with level 5 can access all commands. Table B.
also lists the expanded name of each command.
(For additional security information, refer to the Op-
erations section of this manual.)
Table B. Command/Message Names and Access Levels
COMMAND/MESSAGE EXPANDED NAME
ACCESS
LEVEL
ACT-USER Activate User 1
ALW-SWDX-EQPT Allow Switch Duplex Equipment 4
CANC-USER Cancel User 1
CONN-COM Connect Communication 4
CPY-MEM Copy Memory 4
DISC-COM Disconnect Communication 4
DLT-EQPT Delete Equipment 4
DLT-INVENTORY Delete Inventory 4
DLT-PORT Delete Port 4
DLT-USER-SECU Delete User Security 5
ED-COM Edit Communication 3
ED-DAT Edit Date 4
ED-EQPT Edit Equipment 3
ED-INVENTORY Edit Inventory 3
ED-PID Edit Password Identification 1
ED-PORT Edit Port 3
ED-SSM-EQPT Edit Synchronization Status Message Equipment 4
ED-SSM-PORT Edit Synchronization Status Message Port 3
ED-USER-SECU Edit User Security 5
ENT-EQPT Enter Equipment 4
ENT-INVENTORY Enter Inventory 3
ENT-PORT Enter Port 4
ENT-USER-SECU Enter User Security 5
INIT-COM Initialize Communications 3
INIT-LOG Initialize Log 3
To Next Page
Loading...
Need help?
General
