Issue 2: Sep 99 TMSL 097-44018-26
Page 143
COMMAND CODE: SET-REPTMODE-PORT
PURPOSE
SET REPORT MODE PORT
This command sets the message type (REPT-ALM-PORT or REPT-ALM-EQPT) used to report autono-
mous port-alarm messages.
INPUT FORMAT
SET-REPTMODE-PORT:[<tid>]::<ctag>::<modetype>;
Note: Automatic equipment-alarm messages are always reported as REPT-ALM-EQPT messages.
EXAMPLE
Input:
SET-REPTMODE-PORT:::119::ALW;
Response:
SANJOSE-114 1997-12-08 15:04:13
M 119 COMPLD
;
This example, tagged as command 119, sets automatic port-alarm messages to be reported as REPT-
ALM-PORT messages.
modetype meaning
ALW automatic port-alarm messages are reported as REPT-ALM-PORT
messages
INH automatic port-alarm messages are reported as REPT-ALM-EQPT
messages
To Next Page
Loading...
Need help?
General
