Symmetricom TimeProvider 500 series Reference Guide

TMSL 097-44018-26 Issue 2: Sep 99
Page 18
COMMAND CODE: ALW-SWDX-EQPT
PURPOSE
ALLOW SWITCH DUPLEX EQUIPMENT
This command transfers the source active status between two DCIM cards. The DCIM cards must be set
for stand-alone operation (not 1+1) via the SET-ATTR-CONT command. In addition, the shelf must be
equipped with ST3 clock cards.
INPUT FORMAT
ALW-SWDX-EQPT:[<tid>]:<aid>:<ctag>;
The parameter values in the table below are as follows:
a=1–2
EXAMPLE
Input:
ALW-SWDX-EQPT::DCIM-1:134;
Response:
SANJOSE-114 1997-12-08 15:04:13
M 134 COMPLD
;
This example, tagged as command 134, causes the source active status to switch to the other DCIM card.
aid meaning
DCIM-a specified DCIM card

Symmetricom TimeProvider 500 series Specifications

General

Brand	Symmetricom
Model	TimeProvider 500 series
Category	Data Loggers
Language	English