Symmetricom TimeProvider 500 series Reference Guide

Issue 2: Sep 99 TMSL 097-44018-26
Page 61
COMMAND CODE: INIT-REG
PURPOSE
INITIALIZE REGISTER
This command resets the specified performance-monitoring storage registers (<montype>) on the speci-
fied equipment. These registers contain performance monitoring information accumulated in previous
intervals. After putting ports into service, it is recommended that this command be used to initialize the
performance-monitoring storage registers on those ports to avoid the possibility of invalid data.
INPUT FORMAT
INIT-REG:[<tid>]:<aid>:<ctag>::<montype>;
The parameter values in the table below are as follows:
a = 1–2 c = 2 e = 2–4 (c > b)
b = 1–2 or ALL d = 1–4 or ALL f = 1–11
aid parameter value meaning
ALL montype ALL all spans of all DCIM, MRC, & PSM cards
DCIM-a-b montype ALL all montypes
BPV bipolar violations register
CRC cyclic redundancy check errors register
MRC-a-d[&&-e] montype ALL all montypes
BPV bipolar violations register
CRC cyclic redundancy check errors register
PSM-f-d[&&-e] montype ALL all montypes
BPV bipolar violations register
CRC cyclic redundancy check errors register
MTIE MTIE performance monitoring register
PHASE1M phase 1-minute register
SLIPS slips register
TDEV TDEV performance monitoring register

Symmetricom TimeProvider 500 series Specifications

General

Brand	Symmetricom
Model	TimeProvider 500 series
Category	Data Loggers
Language	English