TMSL 097-44018-26 Issue 2: Sep 99
Page 22
COMMAND CODE: CPY-MEM (Contd)
INPUT FORMAT (Contd)
The parameter values in the table below are as follows:
a = 1–2 or ALL b = 1–11 or ALL c = 1–12 (1–10 for TOTA-5 & TOTA-M) or ALL
Note: After copying to the GTI card (or ALL), use the RTRV-COND-EQPT command to ensure that the
GTI is in service. If the GTI is not in service, repeat the COPY command. When copying from the GTI
card (or ALL) to the MIS card, the COPY command may be denied with an error code of SROF. If this
occurs, repeat the COPY command.
fromdev todev meaning
ALL MIS from all DCIM, GTI, MRC, PSM, and TO cards to MIS card
DCIM-a MIS from specified card(s) to MIS card
GTI-a
MCA
MRC-a
PSM-b
TO-c
MIS ALL to all DCIM, GTI, MCA, MRC, PSM, and TO cards from MIS
card
DCIM-a to specified card(s) from MIS card
GTI-a
MCA
MRC-a
PSM-b
TO-c
fromdev todev meaning
EXT MIS from external source to MIS card in master shelf
EXP-1 from external source to MIS card in expansion shelf 1
EXP-2 from external source to MIS card in expansion shelf 2
EXP-3 from external source to MIS card in expansion shelf 3
INPUT-1 from external source to input card 1 in master shelf
INPUT-2 from external source to input card 2 in master shelf
parameter value meaning
memclass PGM program that runs the card (used with <fromdev> = EXT only)
DATA card configuration data (not allowed with <fromdev> = EXT)
To Next Page
Loading...
Need help?
General
