To Next Page

To Previous Page

TMSL 097-44018-26 Issue 2: Sep 99

Page 6

comtype This parameter indicates the type of communication device used (X25, MODEM, TERM1,

TERM2, or remote). Refer to the ED-COM command for an explanation of device types.

conddescr This parameter is the condition description which is a text description of the alarm or condition

reported by the system, enclosed within /* and */. The system returns one conddescr per

response message. Valid values for <conddescr> are listed in Table F.

condeff This parameter indicates the effect of the event on the condition of the equipment. If a standing

condition is raised, it can be retrieved using the RTRV-COND-EQPT command with an <aid> of

SHELF. A transient condition does not change the basic state of the equipment. Valid values

for <condeff> are:

SC = standing condition raised

CL = standing condition cleared

TC = transient condition

condtype This parameter is the condition type. When used in a command, it indicates the type of alarm

condition requested. When seen in a response, it indicates the type of alarm condition being

reported, which is further explained in the conddescr parameter. When seen in an automatic

message, it indicates the type of alarm condition reported as either raised or cleared (see the

conddescr parameter). Valid values for <condtype> are listed in Table F.

conttype This parameter is the control type. Refer to the SET-ATTR-CONT command for additional infor-

mation.

With an <aid> of DCIM-ALL, this parameter indicates the input protection mode:

NO = no protection: each DCIM card is stand-alone with 2 inputs

1+1 = 1-plus-1 protection: the 2 DCIM cards operate as 1 card with 4 inputs

With an <aid> of MIS, this parameter indicates the SSM mode (applies to master and all

expansions shelves):

NO = SSM is not supported

SSME = SSM supported for DCIM-EA, EA10-M, and EA20-M cards only

SSMT = SSM supported for DCIM-T and TOTA-M cards only

With an <aid> of TO (timing output card), this parameter indicates the output protection mode

(applies to TO-EA5, EA10, and EA20 cards):

NO = no protection

1-1 = 1-for-1 protection

1+1 = 1-plus-1 protection

With an <aid> of SHELF, this parameter indicates the timing output source selection mode

(applies to master and all expansions shelves):

RVRT = revertive

NRVRT = nonrevertive

Table A. Parameter Definitions (Contd)

PARAMETER DEFINITION

Symmetricom TimeProvider 500 series Reference Guide

Other manuals for Symmetricom TimeProvider 500 series