ALGORITHMS
M5AMBIEN
Rev 1.2 Page 34
R-DELAY 0.0 ms - 300.0ms Individual delay for right channel. Can
be adjusted in 0.1 ms steps.
INSERT
4
off, on This enables you to internally insert a
2nd DSP engine in the M5000 main-
frame i.e. running the DYNAMIC1
algorithm. The insert point of the
TOOLBOX will always send on the
digital audio bus. The INSERT
parameter determines whether the
TOOLBOX algorithm shall the returned
signal (on) of not (off). When set to ‘
on
’
the inserted DSP’s I/O configuration
must
be set to INSERT in the UTILITY
menu.
PAGE 9:
LO-EQ off, on Switches the low eq filter off and on.
MID-EQ1 off, on Switches the mid-eq1 filter off and on.
MID-EQ2 off, on Switches the mid-eq2 filter off and on.
HI-EQ off, on Switches the high eq filter off and on
PAGE 10:
DIAL A DIAL B DIAL C DIAL D
LO-EQ FREQ WIDTH/SLOPE LEVEL
par.eq 19.95Hz - 5.01KHz 0.1 oct - 4.0 oct ±12 dB
notch 19.95Hz - 5.01KHz 0.02 oct - 1.0 oct 0.0dB - off
shelve 19.95Hz - 5.01KHz 3/6/9/12 db/oct ±12 dB
cut 19.95Hz - 5.01KHz Butterw/Bessel
LO-EQ The low frequency filter of the 4-band equalizer. The filter type is
determined by softdial A.
PAGE 11:
4
Older DSP engines needs the MULTIBUS upgrade. In case of problems please contact your dealer or TC
Headoffice in Denmark.
To Next Page
Loading...
Need help?
General
