ALGORITHMS
M5ALGOIN
Rev 1.4 Page 30
ability to de-glitch polyphonic chords
will be enhanced.
DGFILT 500 Hz, 1 kHz, 2 kHz, This filter is used to determine the upper
and 4 kHz. limit of frequencies of your input signal.
The idea is to make the frequency range,
within the pitch shifter, narrower. This
will increase the speed of the pitch
shifting, because the pitch detector
doesn't have to search for so many
frequencies in order to determine the
pitch of the input signal. This con-
clusion is maybe more understandable if
we use the following analogy: Let’s say
you have lost your car keys. It is quite
likely that you would be able to locate
them faster, if you knew they were
somewhere in your garage, than if you
knew they were somewhere in your
house.
PAGE 5:
MIDIPtc off, on MIDI Pitch Bender control. If this is set
to ‘
on
’ the PITCH-1 algorithm will react
on Pitch Bender control from a MIDI
keyboard.
MIN -1200 - 1200 This determines the minimum key range
value for the Pitch Bender Wheel.
MAX -1200 - 1200 This determines
the maximum key range value for the
Pitch Bender Wheel.
To Next Page
Loading...
Need help?
General
