ALGORITHMS
M5ALGOIN
Rev 1.4 Page 38
after the input PPM meter, and will not
affect the input PPM reading, also if using
an analog input, make the analog INLEV
adjustment in the G-LEVELS-menu under
UTIL before setting this control. If the red
overload LED flashes, turn down INLEV
a couple of dBs. The control does not
affect the bypassed signal level. Normally,
you do not have to change the factory
default setting.
OUTLEV off - 0.0 dB. Sets the output level of the program in 0.5
dB steps. The function of this control is to
maximize dynamic range by allowing the
delay algorithm to output maximum
signal to the DA converters. It affects the
output PPM reading. Note that there is a
separate output level control for adjusting
the analog output level. Set the
analog
OUTLEV adjustment in the G-LEVELS-
menu before setting this OUTLEV. The
control does not affect the bypassed
signal level. Normally, you do not have to
change the factory default setting.
PAGE 2:
DELAY-1 1 - 670 mS (1.36 Sec.)
7
Sets the delay time for the left side.
DELAY-2 1 - 670 mS (1.36 Sec.)
1
Sets the delay time for the right side.
HICUT 500 Hz - flat High cut filter, shelving type. Provides an
overall high frequency rolloff (6 dB per
octave) that is well suited to make the
delay effect sound warmer. Sets the cutoff
frequency of the overall high cut filter in
1/3-octave steps.
ATT -40 - 0.0 dB The attenuation control sets the amount of
high frequency rolloff determined by
HICUT in 0.5 dB steps.
7
If high memory is installed (Idx=64K check your index memory under UTILITY menu CONFIG) max. delay
time is 1.36 Sec., otherwise max. delay time is 670 mS. (Idx=32K).
To Next Page
Loading...
Need help?
General
