ALGORITHMS
M5ALGOIN
Rev 1.4 Page 44
play tr Select this mode in order to enable audio
triggering. Manual start of sample can
still be done from the DO-button.
When the FAST TRIG chip is installed
on the AD/DA converter board, analog
audio triggering can especially be used
for fast drum triggering.
Be aware that
the FAST TRIG
*
is an 8 bit converter
device, so do not set the MIX to
anything other than 100%
. You can
hear the low quality (but fast) 8 bit
trigger signal if you bypass when armed
for audio triggering.
loop After pressing the DO-button the
selected sample will loop the sample in
its full length from start point to end
point. You can abandon the loop by
pressing the UNDO-button. Everytime
the DO-button is pressed the sample is
started from the start point.
rec. Start recording by pressing DO and stop
recording by pressing UNDO. If UNDO
is
not
pressed the recording will
continue to the end of total sample time
(FREE-MEM). You can then edit your
sample as you wish.
rec. tr This mode enables the possibility to start
recording from the audio inputs. Manual
start with DO-button is also possible.
delete
*
This is for deleting one of the samples.
Select the sample you want to delete and
press DO and confirm the deletion.
CAUTION: When a sample is deleted
you can not undo the event !
After
deleting one of the samples, the rest
automatically are packed in memory so
maximum sampletime again is available.
pack
*
When a sample has been truncated using
the start and end point parameters (
see
page 3
) the action can be made
permanent and the available memory is
"packed" in order to free deleted space
for new samples.
CAUTION: You can
not undo a "pack" event, the sample
is trimmed permanently !
To Next Page
Loading...
Need help?
General
