ALGORITHMS
M5ALGOIN
Rev 1.4 Page 46
time according to RECMODE and
FREEMEM.
STATUS
ready?, armed!, playing,
Read Only. Shows the current action of
record., looping the sampler.
PAGE 3:
START 0.00s - (end point) Edit start point of current sample. When
the sample is edited, a small part of the
sample playbacks for cue listening.
FINE 0.00ms - 9.99ms Fine adjustment of start point with cue.
END 0.00s - (max. sampletime) Edit end point of current sample. When
the sample is edited a small part of the
sample playbacks for cue listening.
FINE 0.00ms - 9.99ms Fine adjustment of end point cue.
PAGE 4:
RECMODE mono, stereo Switch between mono- or stereo sampling.
Max. sampletime will be displayed in
FREEMEM according to chosen mode .
FIL-RES
*
8, 16, 18, 24 bit
For disk storage only
. This is the
wordwidth used when storing samples.
The higher FILE resolution the higher
disk storage capacity is required (See
table 1).
FREEMEM
*
(Read Only) Displays the total available sample time
in seconds according to RECMODE and
installed SIMM. After power up all
memory installed is cleared and available
for sampling.
Max. sampletime
Mono Stereo Mono Stereo
Samplerate
44.1 KHz 44.1 KHz 48 KHz 48 KHz
Standard 1,5 0,8 1,4 0,7
High Mem (5IRAM) installed 3,0 1,5 2,8 1,4
Dynamic RAM installed
1 MByte 23,8 11,9 21,8 10,9
4 MByte 95,1 47,6 87,4 43,7
16 MByte 380,4 190,2 349,5 174,8
Table 2.
REVERSE off - on If ‘
on
’ current sample is played back in
reverse.
To Next Page
Loading...
Need help?
General
