ALGORITHMS
M5ALGOIN
Rev 1.4 Page 48
PAGE 7:
TRIGGER manual, pedal, midi
*
Enables different trigger modes
(playback of samples). When set to
'manual',
triggering of sample can be
done by pressing the DO-button. Choose
'pedal'
to trig sample also from the
pedal connector on the back panel of the
M5000 (normally open contact). You
can also trigger your samples from a
MIDI
*
keyboard (see next page).
TRIGLEV off - 0.0dB Sets the threshold level for the audio
triggering input. The
fast trig
will not
respond to input levels below -30dB.
DEADBND -20dB - 0.0dB Sets the level the audio level needed to
go below TRIGLEV before a new audio
trig is possible. Active only when audio
triggering.
RETRIG 0.03s - 1.0s - to end A trigger mask that sets the time that
must pass before a new audio trig is
possible. With 'to end' selected audio
retrig is not possible before sample has
ended.. Active only when audio
triggering.
PAGE 8:
MIDIkey
*
0 - c0 - c7 - 127 When MIDI trigger is chosen
(TRIGGER=midi) the samples can be
triggered from a MIDI device, i.e. a
MIDI keyboard. Select a keynote on
which you want the sample to respond.
Note: ACTION (page 2) must be set to
play!
NOTEoff
*
off - on Enables the M5000 to respond to
'note
off'
MIDI command. When NOTEoff is
set to
off
the selected sample will
playback its whole length regardless of
the key is released. When NOTEoff is
set to
on
the selected sample will stop
playback when the keyboard key is
released.
To Next Page
Loading...
Need help?
General
