TDSi DIGIgarde PLUS - Table 1 Single Factor Verification Modes

Introduction
DIGIgarde PLUS User Guide
Copyright © 2012 TDSi Last Change
Page 4 13 May, 2016
Verification factors
Verification factorsVerification factors
Verification factors
The DIGIgarde PLUS Fingerprint reader supports single, dual and three factor
verification modes. Table 1, Table 2 and Table 3 provide a description of the
verification modes and shows how to use them. In the following table and in the
DIGIgarde PLUS menu, the following symbols are used:
/ means OR; + means AND
FP: Fingerprint; PW: Password (5-digit); ID: User ID (9-digit); RF: smart card
Table 1 Single factor verification modes
Mode Description
FP Only verify fingerprint using one of the following methods:
Enter ID; verify FP (1:1
verification)
Verify FP (1:N verification)
Present RF card; verify FP (1:1
verification)
ID Only verify the User ID
Enter ID through keypad
PW Only verify the password
Enter ID; enter PW
Present RF card and enter PW
RF Only verify the RF card
Present RF card
FP/PW Verify fingerprint OR password
ID and FP (1:1)
FP (1:N)
Enter ID; enter PW
Present RF card; enter PW
FP/RF Verify fingerprint or RF card
Enter ID; verify FP (1:1
verification)
Verify FP (1:N verification)
Present RF card
PW/RF Verify password or RF card
Present RF card
Enter ID; enter PW
FP/PW/RF Verify fingerprint or password or RF card
Enter ID; verify FP (1:1
verification)
Verify FP (1:N verification)
Enter ID; enter PW
Present RF card