TDSi DIGIgarde PLUS - Daylight Saving Time

Device Settings
DIGIgarde PLUS User Guide
Copyright © 2012 TDSi Last Change
Page 34 13 May, 2016
4.1.4
4.1.44.1.4
4.1.4 Daylight Saving Time
Daylight Saving TimeDaylight Saving Time
Daylight Saving Time
To change daylight-saving time options:
1. To view further System Opt menu categories, use the ▼ key to scroll down
past the first three categories.
2. To set the daylight saving options, select DLST and press the OK button.
The DLST menu is displayed.
3. To enable or disable daylight saving time, select DLST (the current setting is
displayed alongside) and press the OK button.
4. Use the ▲▼ keys to cycle between the settings: N(o) or Y(es).
5. Press the OK button to confirm your selection.
6. If you have enabled daylight saving time, use the Enter DLST and Standard
settings to identify the beginning and end of the daylight saving time period
respectively.
There are two ways to specify the start and end dates, as determined by Date
Mode:
Mode 1 (default)
In this mode, you specify the precise date and time. In the Enter DLST and
Standard menus, DIGIgarde PLUS shows the date/time in the format:"month,
day hours: minutes".
For example: 2am on the 4
th
September is denoted by:09 04 02 00
Mode 2
In this mode, you specify the specific month and day of the week but not the
precise date. A calendar month can have up to 6 weeks (although the first and
DLST
↓
► Date Mode Mod
e1
Enter DLST
Standard
DLST
↓
► DLST N_
Date Mode M
ode1
Enter DLST
DLST
↓
► DLST N
Date Mode M
ode1
Enter DLST
System Opt
↑
► DLST
Wiegand
Adn Options