TDSi DIGIgarde PLUS - Wiegand Format

Device Settings
DIGIgarde PLUS User Guide
Last Change Copyright © 2012 TDSi
13 May, 2016 Page 35
sixth will be partial weeks) so in Mode 2 you can specify, say, the first Sunday in
the month by choosing week 1. The week shows the date/time as "Month -
Weeks- week hours: minutes”.
For example: 2am on the first Sunday in September is denoted by: 9 1 6 02:00
If you selected a Sunday in the sixth week of month, and in a particular calendar
year the month only contained five weeks, DIGIgarde PLUS would assign the last
Sunday of the month even if this occurred in week four.
4.1.5
4.1.54.1.5
4.1.5 Wiegand
Wiegand Wiegand
Wiegand f
ff
format
ormatormat
ormat
Input Setting
Input SettingInput Setting
Input Setting
Input Setting Use Default
Input Device FP Device or RF Reader FP Device
Outp
OutpOutp
Output Settings
ut Settingsut Settings
ut Settings
Output Setting Use Default
Output User
Site Code 256
Pulse Width 100
Pulse Interval 900
Output Setting
↓
►Output Format
Output User
Site Code
256
Input Setting
► Input Device
FP Device
ESC
OK
Wiegand
► Input Setting
Output Setting
DLST
↓
► Date Mode M
ode1
Enter DLST
Standard