TDSi DIGIgarde PLUS - Log Options; LED Mode; Table 12 Log Options

Device Settings
DIGIgarde PLUS User Guide
Copyright © 2012 TDSi Last Change
Page 38 13 May, 2016
4.4
4.44.4
4.4 Log
Log Log
Log o
oo
options
ptionsptions
ptions
The fourth option on the Options menu is Log Options. The DIGIgarde PLUS logs
three types of data:
Supervisor Log
Attendance Log
Fingerprint Alarm Log
Use the Log Options settings to determine when the unit is to indicate that the logs
are reaching its internal memory capacity.
Table 12 Log options
Log Option Use Default
Alm SuperLog Supervisors Log: number of remaining log
entries when unit issues memory capacity
warning
99
Alm AttLog Attendance Log: number of remaining log
entries when unit issues memory capacity
warning
99
FRecordAlarm Fingerprint Record Log: number of remaining
log entries when unit issues memory
capacity warning
99
ReCheck Min Set the minimum period for relogging a user.
If a user is verified a second time within this
period, only a single log entry is recorded.
0
4.5
4.54.5
4.5 LED
LED LED
LED m
mm
mode
odeode
ode
The Reader LED default is set to bi-colour. The LED line is held at approximately
5V, and in normal mode will pulse to 0 Volts every 2 seconds (red LED). Upon
access granted this will activate to 12 Volts (Green)for the duration of the Lock time
(see page 48).
In ACU mode the LED is driven from the ACU.
4.6
4.64.6
4.6 Data
Data Data
Data o
oo
out
ut ut
ut t
tt
type
ypeype
ype
Wiegand or Magnetic
The reader can output the User ID with or without a site code depending upon
which setting you have chosen. For connection to TDSi Access Control Panels use
37-bit Wiegand (28-bit data, 8-bit even parity, 1 bit odd parity) or Magnetic
protocols.
Comm Opt
►BaudRate 115200
Dev Num 1
Net Speed
AUTO
Options
↑
Power Mng
Comm Opt
►
Log
Opt