TDSi DIGIgarde PLUS - ► Enrol Fpcard; Table 8 Card Enrolment Options

User Setup
DIGIgarde PLUS User Guide
Last Change Copyright © 2012 TDSi
13 May, 2016 Page 29
3. Press the OK button to select the FPCard Manage menu option.
Table 8 Card enrolment options
Command Before command After command
DIGIgarde
PLUS
Card DIGIgarde
PLUS
Card
Enrol FP Card ID Template,ID
Copy to Card Template,ID Template,ID Template,ID
Register FP Card Template,ID ID Template,ID
Unregister FP Card Template,ID Template,ID ID Template,ID
Delete FP Card No action Template,ID No action
Copy Crd to Rdr ID Template,ID Template,ID Template,ID
Move Rdr to Crd Template,ID ID Template,ID
3.3.1
3.3.13.3.1
3.3.1 Enrol
Enrol Enrol
Enrol FP Card
FP CardFP Card
FP Card
Register a user by enrolling their fingerprint and storing the template in a Mifare
card. The template is not stored locally on the DIGIgarde PLUS and the unit will be
unable to authenticate the user without their card.
To enrol a user with a smart card:
1. Select Enrol FPCard.
2. Enter a new user ID or Press OK to accept the spare ID offered by the
DIGIgarde PLUS. Press OK.
3. Enter Special N to continue or Y to make this a by-pass card.
4. Enrol the user’s fingerprint as described on page 25.
5. If this is successful, the “Continue?” prompt is displayed. Press OK to enrol
further fingerprints in the same manner or press ESC to continue.
6. When prompted to do so (“Show the card”), present the Mifare card to the
front of the DIGIgarde PLUS. The fingerprint information is written to the
card and a “Succ” message is displayed.
NOTE. Ensure that you keep the card on the reader until the template has been
written and the “Success” message has been displayed.
FPCard
Manage
↓
► Enrol FPCard
Copy to Card
Reg FPCard