TDSi DIGIgarde PLUS - Assigning a User to a Group; Setting a Users Time Patterns; Table 14 User Access Options Menu

Standalone Mode
DIGIgarde PLUS User Guide
Copyright © 2012 TDSi Last Change
Page 46 13 May, 2016
Table 14 User Access Options menu
Access Control
Option
Use Default
Belong to GRP Assign an individual user to a Group. 1
Use Grp TPs* Choose whether to apply time patterns from the
user’s assigned group (Y/N). If you select N(o),
the individual’s time patterns remain active even
though the user is a member of a group with
potentially different access time patterns.
Y
TP1 Time patterns active for this user.
Use GRP TPs and the individual TP settings are
linked. If you have enabled Use Grp TPs,
TP1,2&3 show the numbers of the time patterns
assigned to the user’s group. If you subsequently
edit any of these fields, Use GRP TPs is
automatically disabled.
1
TP2
TP3
VERType Select a verification process for this user (see
page x). If Use Grp VS is enabled, this setting is
ignored and the group’s verification process is
required.
FP/PW/RF
Use Grp VS Choose whether to use the verification process
specified for the group.
Y
5.5.2
5.5.25.5.2
5.5.2 Assigning a
Assigning a Assigning a
Assigning a u
uu
user to a
ser to a ser to a
ser to a g
gg
group
rouproup
roup
By default, each new user is enrolled into group 1. If you want to assign the user to
a different group:
1. Select the Belong to GRP option.
2. Press the OK button.
3. Use the ▲▼ keys to select the number (1-5) of the required group.
Now choose the user’s access options: their time patterns and verification method.
By default, a user inherits the time patterns and verification method assigned to the
group. If preferred, you can apply user-specific time patterns and an independent
verification method instead. These options are described in the next two sections.
5.5.3
5.5.35.5.3
5.5.3 Setting a
Setting a Setting a
Setting a u
uu
user’s
ser’s ser’s
ser’s t
tt
time
ime ime
ime p
pp
patterns
atternsatterns
atterns
Having assigned the user to a group, decide if you want the user to inherit the
group’s time patterns or assign custom time patterns (see below).
By default, a new user inherits the time patterns of their assigned group. If you
want to apply custom time patterns:
1. Select the Use Grp TPs option. Press the OK key.
2. Use the ▲ or ▼ key to change the setting to N. Press OK.
User 00001 Opt
↓
►Belong to GRP 1
Use Grp TPs Y
TP1
User Acc Opts
ID 000000001
ESC
OK