TDSi DIGIgarde PLUS - Defining Duress Options; Table 16 Duress Options

Standalone Mode
DIGIgarde PLUS User Guide
Copyright © 2012 TDSi Last Change
Page 50 13 May, 2016
5.9
5.95.9
5.9 Defining Duress
Defining Duress Defining Duress
Defining Duress o
oo
options
ptionsptions
ptions
Duress settings allow you to assign fingerprints, passwords and/or User IDs to set
off covert alarms in the event of a user being forced to verify access against their
will.
Table 16 Duress Options
Duress Option Use Default
Duress FP Manage duress fingerprint enrolment for new or
existing users.
Help Key Assign the fingerprint recorded under Duress FP
as a Help key. When enabled, verification of the
fingerprint will trigger the alarm.
N
1:1 Trig Choose whether the alarm should be triggered
when the user enters their ID before fingerprint
verification.
N
1:N Trig Choose whether the alarm should be triggered
when the user does not enter their ID before
fingerprint verification.
N
Pwd Trig Choose whether the alarm should be triggered
when the user enters their password.
N
Alarm Delay Delay the triggering of the alarm when a user
verifies a duress fingerprint or password (0-255
seconds)
10
Example:
1:1 Trig: N
1:N Trig: Y
Pwd Trig: N
Alarm Delay: 60
The duress alarm is triggered if a user verifies their
fingerprint without firstly entering their ID. The alarm is
set off 60s later.
Duress FP
↓
► New Enrolment
Def. Duress FP
Undef DuressFP
Duress Options
↓
► Duress FP
Help Key
1:1 Trig