TDSi DIGIgarde PLUS - Alarm; Resetting the Alarm

Standalone Mode
DIGIgarde PLUS User Guide
Last Change Copyright © 2012 TDSi
13 May, 2016 Page 49
5.8
5.85.8
5.8 Alarm
AlarmAlarm
Alarm
The alarm connections (see page16) are suitable for...
The Alarm is triggered if:
The Door Sensor detects that the door is not in its expected state after a user
has been verified (see page 48)
The Alarm Count is exceeded
After a specified number of failed verification attempts by a user (see page 43).
A Duress fingerprint or password is verified (see page 50).
A user presses the Help ID (see page 50).
5.8.1
5.8.15.8.1
5.8.1 Resetting t
Resetting tResetting t
Resetting the alarm
he alarmhe alarm
he alarm
If the alarm is triggered, an additional option is displayed on the main menu:
NOTE. DIGIgarde PLUS is equipped with an anti-tamper mechanism triggered if
the unit is removed from its back plate while power is applied (see page 9). If this
occurs, the screen displays the message “SYSTEM BROKEN”.
Menu
↑
Options
Sys Info
►
Turn Off Alarm