TDSi DIGIgarde PLUS - Data out Type; Standalone Mode; The Access Control Menu; Table 13 Access Options Menu

Standalone Mode
DIGIgarde PLUS User Guide
Last Change Copyright © 2012 TDSi
13 May, 2016 Page 43
5.3
5.35.3
5.3 The Access Control
The Access Control The Access Control
The Access Control m
mm
menu
enuenu
enu
To alter any of the DIGIgarde PLUS user access settings:
1. Press the Menu button and, if necessary, verify your identity.
2. Press the ▼ key to select Options.
3. Press the OK button. The Options menu is displayed.
4. Use the ▼ key to scroll down to Access Options. Press the OK button. The
Access Options menu is displayed (see Table 13).
Table 13 Access Options menu
Access Options Use Default
Define TP Define weekly time patterns; up to 50 1
User Acc Opts User Account Options: assign individual users to
groups, apply time patterns and verification
methods.
Grp TP Define Define Group time period: Is used to set group
unlocking time. 1-5, time period 1-50.
1
Access Comb (Unlocking combination): define up to 10
different 5-digit unlocking combination codes
(see page 47); each combination code is
composed of the number and order that group
users must be validated for access.
Lock Time that the lock drive is powered (0-254
seconds). Set to zero to lock the door to all
users.
10
Dsen.Delay Delay time (in seconds) after the lock is powered
before the DIGIgarde PLUS checks on the state
of the door sensor. If the door state at this time
is anything other than that set in Dsen Mode
10
Access Options
↓
► Define TP
User Acc Opts
GRP TP Define
Options
↨
LED Mode
Data Out Type
►
Access Options
Options
↓
► System Opt
Power Mng
Comm Opt
Menu
↓
User Manage
► Options
Sys Info